Auto CPAP / CPAP System User Manual V1.0
15 / 51
Consumption‖) may damage the device or cause device failure.
• Connect to appropriate power for proper operation of the device.
• Inspect the power cord often for any signs of damage. Replace a damaged cord
immediately.
IMPORTANTS!
• After interruption and restoration of the power supply, the device will restore its
pre-interruption working status automatically.
• To remove AC power, disconnect the power cord from the power outlet.
11.4 Assembling the Tubing / Heated Tubing and Mask
(1) Connect one end of the tubing to the air outlet of the device, as shown in Fig. 11-5.
Fig. 11-5
(2) Connect the heated tubing joint to the air outlet of the device, and then insert the power
plug into the heated tubing port on the back of the device, as shown in Fig. 11-6.
Power Plug
Heated Tubing
Air Outlet
Heated Tubing
Heated Tubing Joint
Fig. 11-6
If the heated tubing is connected correctly, the icon will become a number in the Main
Interface on the screen of the device , as shown in Fig. 11-7.
To Next Page
Loading...
