BMC REACTHEALTH Luna G3 APAP User Manual

Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual
10 / 49
Auto On
With this feature, the device automatically initiates therapy when you breathe into
the mask. This feature is always enabled.
SmartC
In CPAP mode, if SmartC is set to on, the device can adjust Treat P according to the
patient's respiratory event during a certain time.
SmartA
In AutoCPAP mode, if SmartA is set to on, the device can adjust Initial P and Min
APAP according to the patient's respiratory event during a certain time.
Initial P
Initial pressure.
Min APAP
Minimum Automatic Positive Airway Pressure.
CPAP
Continuous Positive Airway Pressure.
iCode
A feature that is intended to give access to compliance and therapy management
information. The “iCode” consists of six separate codes displayed in the Patient
Menu, each code is a sequence of numbers. The “iCode QR+” display
two-dimensional codes.
LPM
Liters Per Minute.
OSA
Obstructive Sleep Apnea.
Patient Menu
The display mode in which you can change patient-adjustable device settings,
such as the starting pressure for the Ramp feature.
Ramp
A feature that may increase patient comfort when therapy is started. It begins from
a low pressure and then gradually increases to the prescribed setting pressure so
that the patient can fall asleep more comfortably.
Reslex
A therapy feature that is enabled by your physican to provide pressure relief during
exhalation.
Standby State
The state of the device when power is applied but the airflow is turned off.
min
Means the time unit “minute”.

BMC REACTHEALTH Luna G3 APAP Specifications

General

Brand	BMC
Model	REACTHEALTH Luna G3 APAP
Category	Respiratory Product
Language	English