Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual
36 / 49
or does not function well, please do not repair and use it by yourself, but replace it
immediately.
• Failure to clean in accordance with the User Manual may result in reduced
performance of the heating tubing or shortened product life.
• After cleaning and before reuse, the tubing should be inspected for holes, creases
and tears.
18.6 Cleaning and Replacing the Air Filter
(1) Open the air filter cap to remove the air filter. Attach a new air filter to the filter
cap, as shown in Fig. 18-7.
Fig. 18-7
(2) Install the filter cap containing the air filter to the device, as shown in Fig. 18-8.
Fig. 18-8
(3) When the filter is dirty, the filter can be cleaned as follows:
Hold the air filter and align it with the tap water flow. Rinse the air filter with running
water. When cleaning, gently press the air filter, but do not pull the air filter.
Allow the filter to air dry completely before reinstalling it.
CAUTION: Never install a wet filter into the device. You must ensure sufficient drying
time for the cleaned filter.
CAUTIONS!
• To avoid material damage, do not place the spare air filter in direct sunlight,
humid environments, or temperatures below the freezing point. The air filter should
be replaced every 6 months (It may be replaced more frequently based on actual
sanitary conditions).
• Operating the device with a dirty air filter may stop it from working properly and
may cause damage to the device.
To Next Page
Loading...
Need help?
General
