BMC REACTHEALTH Luna G3 APAP User Manual

Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual
40 / 49
Problem
Possible Cause
Solution(s)
Water in mask
When the humidifier is used,
the humidified air tends to
condense in the cold
tubing and mask if the
room temperature is low.
Turn the humidity setting down,
or raise the room temperature.
Place the tubing under the
quilt, or use the tubing cover.
Hang the tubing loosely, and
the lowest part of the tubing
should be lower than the
patient's head.
Nasal, sinus, or
ear pain
Sinus or middle ear
inflammation.
Contact your physician
immediately.
Discomfort due
to inability to
adapt to the
treatment
pressure
The patient will feel
uncomfortable when the
treatment pressure is higher
than 13 cmH
2
O. However,
the treatment pressure is
determined according to
the patient's prescription,
and cannot treat sleep
apnea if the treatment
pressure is set too low.
Patients may experience a
variance in time to acclimate
to their therapy.
If the problem persists, contact
your physician or home care
company for assistance.
Obstructive
sleep apnea
symptoms recur
There are many causes of
recurring symptoms
including weight change,
medication or alcohol, and
poor mask fit.
Contact your physician for
assistance.
The device is
too noisy
The tubing is not
connected properly.
Reconnect the tubing properly.
Air delivered
from the
device is
abnormally hot
The air inlet of the device
may be partially blocked,
leading to insufficient
airflow into the device.
Replace the air filter (refer to
18.6 Cleaning and Replacing
the Air Filter / PM2.5 Filter), and
clean the air inlet.
Place the device in an area
where air flows freely, and
make sure the device is at least
20 centimeters away from the
wall, curtain, or other things.

BMC REACTHEALTH Luna G3 APAP Specifications

General

Brand	BMC
Model	REACTHEALTH Luna G3 APAP
Category	Respiratory Product
Language	English