Luna
®
G3 APAP / Luna
®
G3 CPAP User Manual
44 / 49
Guidance and manufacturer's declaration - electromagnetic immunity
The device is intended for use in the electromagnetic environment specified
below. The user of the device should make sure that it is used in such an
environment.
Electromagnetic
Environment - Guidance
Electrostatic
discharge
(ESD)
IEC 61000-4-2
±8 kV contact
±2 kV, ±4 kV,
±8 kV, ±15 kV
air
±8 kV contact
±2 kV, ±4 kV,
±8 kV, ±15 kV
air
Floor should be wood,
concrete or ceramic tile.
If floors are covered with
synthetic material, the
relative humidity should
be at least 30%
Electrical fast
transient / burst
IEC 61000-4-4
±2 kV for
power supply
lines
±2 kV for
power supply
lines
Mains power quality
should be that of a typical
commercial or hospital
environment
±1 kV
Line (s) to line (s)
±1 kV
Line (s) to line (s)
Mains power quality
should be that of a typical
commercial or hospital
environment
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
0% U
T
; 0.5
cycle
At 0°, 45°, 90°,
135°, 180°,
225°, 270° and
315°
0% U
T
; 1 cycle
70% U
T
; 25 / 30
cycle
At 0°
0% U
T
; 250 /
300 cycle
0% U
T
; 0.5
cycle
At 0°, 45°, 90°,
135°, 180°,
225°, 270° and
315°
0% U
T
; 1 cycle
70% U
T
; 25 / 30
cycle
At 0°
0% U
T
; 250 /
300 cycle
Mains power quality
should be that of a typical
commercial or hospital
environment. If the user of
the device requires
continued operation
during power mains
interruptions, it is
recommended that the
device be powered from
an uninterruptible power
supply or a battery
Power
frequency
(50 Hz / 60 Hz)
magnetic field
IEC 61000-4-8
Power frequency
magnetic fields should be
at levels characteristic of
a typical location in a
typical commercial or
hospital environment
Note: U
T
is the AC mains voltage prior to application of the test level.
To Next Page
Loading...
Need help?
General
