BMGi TMT 800LS - Service Schedule; Warranty

Service schedule
The TMT 800LS gate operator, much like a car, will provide many years of excellent service if a service schedule is
carried out at regular intervals. Follow these basic checks and do repairs in time to get the most out of your operator.
WEEKLY
• Clear away any dirt, sand, stones or foliage collected on the gate rail.
• Clear away any branches, shrubs or grass that might interfere with the movement of the gate.
MONTHLY
• Check for damage or cracks to the motor lid. Although the operator lid is designed for outside conditions, stones
and severe hail may damage it. A cracked lid should be immediately replaced as water and dirt will damage the
operator.
• Check physical end stops are secure and in place - see Site Setup page 6
• Check for insect and reptile infestations.
It is recommended that moth balls be placed inside the operator housing to discourage these infestations
which can cause damage.
EVERY 6 MONTHS
• Place the motor into manual mode and test the gate by opening and closing slowly, take note of any tight sections
you may feel.
• Check for any battery leaks if you have added a battery, these can cause damage to the wiring.
• Check that the controller and other accessories are rmly in place and are not hanging loose.
• Check that the limit brackets on the racking have not shifted.
• Check guide rollers on the gate
• Check all brackets are secure.
• Check the motor is rmly in place and cannot move.
• Check the rack for any damaged teeth.
Warranty
Limited 2 Year Warranty
BMG’s 2 year limited warranty covers the motor and control board, it excludes any other components that
might have been supplied with the operator such as a transformer or remotes. This warranty
explicitly only covers the repair, components and labour carried out a BMGi, all other costs will be for the
account of the purchaser.
2 year - motor and control board
1 year - transformer
6 months - remotes (it is expressly noted that remotes and batteries carry a six month warranty due to the
nature of these products being such that they are subject to possible misuse)
This warranty does not apply if:
* the operator was subjected to misuse,
* the operator was installed contrary to the specications provided in the manual,
* to any product being installed within 800mtrs of the sea or other body of water of equivalent or greater salt
concentration
* any attempt has been made to repair the goods by any workshop and/or person not authorised to do so
by BMG or
* if goods have been repaired using components not tested, passed or authorised by BMG
This warranty does not cover:
* any acts of god, including lightning, hail, water, power surge, insect damage or corrosion,
* consumables including but not limited to: batteries, fuses, globes, sensitivity adjustment, transmitter and
receiver range
* the transport, or costs associated with the transport, of the defective product to a designated BMG
contractor or other third party costs
* any other costs that may have been incurred by the purchaser or any other party or
* on side repairs