SAFETY PRECAUTIONS
WARNING
Correct installation is the most critical factor in ensuring the safe use of the TrailSafe
If every consideration of these instructions has been satisfied, the TrailSafe will be
safe to operate.
Before wiring / servicing TrailSafe, disconnect it from all power sources.
The pull pin should be tested before use to confirm the effectiveness of contacts,
particularly if exposed to salt water.
The TrailSafe is a high precision electronic product. It contains no user-serviceable
parts inside. Do not try to dismantle, modify or repair it yourself. Disassembly,
service or repair by an unauthorised person will void the warranty.
It is essential the house battery is well maintained and must have at least 50% of
nominal capacity available.
It is essential all wiring is protected by fusing close to any power source.
Please read the Safety Precautions before installing or using the TrailSafe series.
Be sure to observe all precautions without fail. Failure to observe these instructions
properly may result in property damage or personal injury which, depending on the
circumstances, may be serious and cause loss of life.
After completing installation of the TrailSafe, conduct a trial operation to check for
faults. Please refer to INITIAL SELF TEST FOR TRAILSAFE section to check for faults.
4
To Next Page
Loading...
