DLC50 Control Panel Installation and Operation Manual | Doc. No. 6051439500 Rev. A
Broadcast Microwave Services 25
6 SPECIFICATIONS
Products Controlled: CCII-(x)LP, BPA-(x), all CTxxxx exciters and PA’s
Operating Temp: -20 to +60 deg. C (MIL STD 810)
Dimensions: 1.47” H x 5.72” W x 4.07” D (less connectors)
Weight: ≤ 1.0 lb.
Panel Fasteners: “Dzus” type, 2 places, color black, level with front of panel; dimensions and fastener
locations conform to MIL-SPEC MS25212C
System Control: On/Off Toggle Switch controlling system power (control signal)
TX Control: Dedicated TXEN key. Status is shown on bottom line of display above TXEN key.
RF Power: Menu selection, or hot-key (user selectable).
LEDs: a. ALM – Yellow (green in NVIS versions) summary alarm (details listed on second line
of display)
b. Actuator Up – Green (stowed)
c. Actuator Down – Yellow (deployed) (green in NVIS versions)
Backlight for panel text: Always on (green)
Display: OLED; Graphical and 3-lines of text. Top line is double size.
Reports to display: Faults: Loss of frequency lock (transmitter automatically enters standby mode)
TX serial com
RX serial com
TX Fault (general Transmitter fault)
Loss of input signal (on equipped transmitters)
Encryption/Scrambling: Dependent on transmitter, options, and licenses, AES, BISS, BMS-4, BMS-6 supported
Presets: Supports 3 types of presets: (20) DLC50 presets, Transmitter presets (number depends
on transmitter model), and Receiver presets (number depends on receiver model)
DLC50 presets: Stores and recalls up to 20 user definable presets - Can store TX frequency, TX
channel, TX frequency, or TX preset, TX power level, Encryption state and key index,
RX frequency, RX channel, RX preset, decryption state and key index, Relay states
(only for manual configured relays).
TX presets: Supports recall of up to 99 TX presets. Number and contents of TX presets are
dependent on TX model.
RX presets: Supports recall of up to 99 RX presets. Number and contents of RX presets are
dependent on RX model.
Expert menu groups: DLC50 presets, TX, RX, Other, Configuration.
Simple menu: User selectable. Can contain: DLC preset, TX frequency, TX channel, TX preset, TX
power level, Encryption, RX frequency, RX channel, RX channel, RX preset,
Decryption, relay control
Hot keys: User Selectable. Can be defined as any of the following: DLC50 preset menu, DLC50
preset, TX frequency menu, TX channel menu, TX channel, TX preset menu, TX
preset, TX power level, RX channel menu, RX frequency menu, RX preset menu,
Encryption on/off, Encryption menu, Decryption on/off, decryption menu, relay 1 toggle,
relay 2 toggle, relay 3 toggle, relay 4 toggle, Dim control menu. .
Menu Navigation: Dual rotary encoder with integral push-button. Keypad keys also function as OK,
Cancel, and Exit.
Panel Dimming: External Linear fade 0-28VDC, and manual trim/override.
Connectors Rear: I/O – DB25-S
Actuator control - PTO2E-10-98S
Power in - PTO2E-12-4P
Connectors Front: USB - USB-A (host),
Remote Serial Port (service port) - 2.5mm stereo audio female
Serial port interfaces: (3) RS-232
Operating Voltage: 24-32 VDC
Power Consumption: <0.1A normal, <1.0A when using antenna actuator
Electrical Compliance: RTCA DO-160, EN2282, MIL-STD-704
Supplied Accessories: All mating connectors.
All Operation and Installation Manuals.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...