1 Extending tool holder
holds all tools by means of
adapters, and for removing
the spark plug
2 1/4" bits
Bits of various sizes
3 3/8" adapter for socket-
head screws, w/f 22
for removing the quick-
release axle from the front
wheel
4 Electric torch
5 Socket
Open-ended spanners of
various sizes
6 Adapter
To accommodate the 1/
4" bits and the 9x12 mm
and the 3/8" universal-joint
adapter
Engine oil
Checking engine oil level
The engine can seize if the
oil level is low, and this can
lead to accidents.
Always make sure that the oil
level is correct.
The oil level varies with the
temperature of the oil. The
higher the temperature, the high-
er the level of oil in the sump.
Checking the oil level with the
engine cold or after no more than
a short ride will lead to misinter-
pretation; this in turn, means that
the engine will be operated with
the incorrect quantity of oil.
In order to ensure that the en-
gine oil level is read correctly,
check the oil level only after a
lengthy trip.
Wipe the area around the oil
filler neck clean.
Allow the engine to idle until
the fan starts up, then allow it
to idle one minute longer.
Switch off the engine.
Make sure the engine is at op-
erating temperature and hold
the motorcycle upright.
with centre stand
OA
Check that the engine is at op-
erating temperature, make sure
the ground is level and firm
and place the motorcycle on its
centre stand.
8
89
z
Maintenance
To Next Page
Loading...
