BMW K 1200 R User Manual

Oil level
Oil-level indicator 1 gives you
an indication of the engine oil
level. You can call up this read-
ing only when the motorcycle is
at a standstill.
The preconditions for the oil level
check are as follows:
Engine at operating temperat-
ure.
Engine idling for at least 10
seconds.
Side stand retracted.
Make sure the motorcycle is
upright.
The readings mean:
OK: Oil level is correct.
CHECK: Check the oil level the
next time you stop for fuel.
---: Oil level cannot be meas-
ured (conditions as stated above
not satisfied).
If you call up another read-
ing on the on-board com-
puter, this symbol remains visible
until the sensor again registers a
correct oil level.
The most recently measured
level is displayed for 5 seconds
when you next switch on the ig-
nition.
The oil sensor might be
defective if the "Check oil
level" message reappears even
though the oil level shown by the
oil tank's level indicator is correct.
In this case, consult your author-
ised BMW Motorrad dealer.
Tyre pressure
monitoring RDC
OE
Viewing tyre-pressure
readings
Switch on the ignition.
Repeatedly press button 1 until
the tyre pressures appear on
the display.
4
53
z Operation

BMW K 1200 R Specifications

General

Displacement	1157 cc
Power	163 hp (120 kW) at 10, 250 rpm
Transmission	6-speed
Compression Ratio	13.0:1
Fuel System	Electronic fuel injection
Final Drive	Shaft drive
Front Suspension	BMW Motorrad Duolever
Engine Type	Liquid-cooled, 4-stroke in-line four-cylinder
Torque	127 Nm at 8, 250 rpm
Fuel Capacity	19 liters
Seat Height	820 mm
Dry Weight	217 kg
Bore x Stroke	79 mm x 59 mm
Fuel Type	Unleaded
Clutch	Wet, multi-disc
Gearbox	6-speed, constant mesh
Frame	Aluminum bridge-type frame
Rear Suspension	BMW Motorrad Paralever
Front Wheel Travel	115 mm
Rear Wheel Travel	135 mm
Front Brake	Dual 320 mm discs, 4-piston calipers
Rear Brake	Single 265 mm disc, 2-piston caliper
ABS	Optional
Maximum Speed	Over 200 km/h