BMW R 1150 R User Manual

11.58
11 34 004 Adjusting valve clearances
•
Set piston to firing TDC on the ignition stroke.
•
Measure valve clearance with feeler gauge.
•
Correct valve clearance with adjusting screw and
tighten locknut.
Valve clearances with engine cold
(max. 35 C/95 F):
Inlet......................................... 0.15 mm (0.0059 in)
Exhaust................................... 0.30 mm (0.0118 in)
X Tightening torque:
Locknut.......................................................... 8 Nm
•
Recheck valve clearances. Feeler gauge must
pull through between valve stem and adjusting
screw with slight resistance.
RS110980

BMW R 1150 R Specifications

General

Displacement	1130 cc
Transmission	5-speed
Dry Weight	219 kg
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
Final Drive	Shaft drive
Engine Type	Air/oil-cooled flat twin (boxer), four-stroke
Power	85 hp (63 kW) @ 6750 rpm
Torque	98 Nm
Fuel Capacity	20.4 liters
Seat Height	800 mm
Front Suspension	Telelever
Rear Suspension	Paralever
Rear Brakes	Single 276 mm disc, 2-piston caliper
Wheelbase	1, 487 mm