BMW R 1150 R User Manual

23.13
Removing gearbox shafts
•
Remove breather tube (1).
•
Heat bearing points in gearbox cover
to 80 °C … 100 °C (176 °F... 212 °F).
•
Remove input shaft (2), output shaft (3) and
intermediate shaft (4) together from the cover.
•
Remove selector fork (5) from intermediate shaft.
•
Mark the selector fork with a felt-tipped pen or
similar.
23 12
Replacing grooved ball bearings
of intermediate shaft
e Attention:
If the grooved ball bearings are replaced, the fully
assembled length must be checked.
•
Pull off the grooved ball bearings with a universal
puller, BMW No. 00 7 500.
•
Press the output-side grooved ball bearing on to
the intermediate shaft.
•
Check/adjust fully-assembled length (a 23.19).
•
Place spacing washer of calculated thickness in
position and press on the input-side grooved ball
bearing.
R21230070
h
80 … 100
w
1
3
4
2
5
00 7 500
KR230070

BMW R 1150 R Specifications

General

Displacement	1130 cc
Transmission	5-speed
Dry Weight	219 kg
Bore x Stroke	101 mm x 70.5 mm
Compression Ratio	10.3:1
Final Drive	Shaft drive
Engine Type	Air/oil-cooled flat twin (boxer), four-stroke
Power	85 hp (63 kW) @ 6750 rpm
Torque	98 Nm
Fuel Capacity	20.4 liters
Seat Height	800 mm
Front Suspension	Telelever
Rear Suspension	Paralever
Rear Brakes	Single 276 mm disc, 2-piston caliper
Wheelbase	1, 487 mm