Vehicle Specifications
Page 48 Bobcat 2200 Gasoline and Diesel Vehicle Operation & Maintenance Manual
MUD TIRE OPTION
All-wheel drive (AWD) vehicles equipped with optional mud tires are intended only for off-road operation; they
are not designed for use on paved surfaces such as asphalt and concrete. Frequent driving on paved sur-
faces will significantly decrease the life of the mud tires. Vehicle performance will also be reduced when driv-
ing on paved surfaces. See following WARNING.
ý WARNING
• To avoid the risk of rollover when operating a vehicle equipped with mud tires on a paved
surface: reduce speed, use extreme caution, and drive slowly in turns.
Bobcat tires are made specifically for the AWD vehicle; therefore, Bobcat recommends that only tires pur-
chased from Bobcat be used on your AWD vehicle.
VEHICLE SPECIFICATIONS
SPECIFICATIONS
GASOLINE
VEHICLES
DIESEL
VEHICLES
POWER SOURCE
Engine: 4-cycle OHV, 614 cc, 20 hp rated, twin-cylinder, air-cooled, with pressure lubrication
system
•
Engine: 4-cycle OHV, 719 cc, 20 hp rated, three-cylinder, liquid-cooled, with pressure lubri-
cation system
•
Fuel system: Side-draft carburetor with float bowl, fixed jets, fuel filters, and impulse fuel
pump
•
Fuel system: Mechanical injection, fuel water separator, fuel filters, and electric fuel pump •
Governor: Automatic ground-speed sensing, internally geared in transmission •
Governor: internal to engine, mechanical, centrifugal ball •
Ignition: Transistor electronic ignition • •
Transmission: Forward and reverse with neutral (4.98:1 forward, 7.79:1 reverse) • •
Electrical system: 12 volt, 500 cca at 0 °F (-17.8 °C), 650 at 32 °F (0 °C). 105-minute
reserve capacity and 35-amp charging capacity
••
Torque converter: Automatic, variable-speed, dry type • •
STEERING/SUSPENSION/BRAKES
Steering: Self-adjusting rack and pinion, Ackerman • •
Suspension:
Front: Independent A-arms with coil-over shock absorbers
Rear: Semi-independent suspension with multi-leaf springs and dual hydraulic
shock absorbers
••
Brakes: Hydraulic brake system – brake pads and discs on each wheel with separate foot-
operated park brake
••
BODY/CHASSIS
Frame/Chassis: Twin I-Beam welded aluminum tube frame • •
Side and rear body: All aluminum ••
Cargo bed: Powder-coated steel ••
Front body: ABS/DR acrylic cap ••
Tires:
All Terrain: 23 x 8.0 – 12 front, 23 x 10.5 – 12 rear; tubeless, 4-ply rated load range
Mud: 23 x 10.5 – 12 front and rear; tubeless, 4-ply rated load range
••
Specifications continued on next page...
To Next Page
Loading...