If you notice that bObi is not working in her usual way or repeatedly runs into a cer-
tain error, you may want to perform a checkup test to nd out what is causing the
issue. bObi’s remote can be used to test all of her sensors and electronic parts in
the span of a few minutes. If bObi does not produce the results as described during
any of her tests, contact our support team for further assistance.
To begin the checkup, make sure the side power button on bObi is turned OFF.
Bring bObi near the remote.
Put bObi in checkup mode
Press and hold the OK button on the remote while you switch bObi’s power back ON.
Continue holding the OK button. The three touch buttons (GO!, WAFFLE, JUICE) on
bObi’s cover will start ashing. While the touch buttons are ashing, simultaneously
press the WAFFLE and JUICE buttons on bObi’s cover with the OK button on the
remote still held down. When bObi makes two beeping sounds, release the OK but-
ton and you will notice that all the digits on her remote become zeroes. bObi is now
in test mode. While in this mode, the three buttons on bObi’s cover (GO!, WAFFLE,
JUICE) stay on, and the 5 LED lights above the buttons ash sequentially.
You may switch between dierent tests by pushing the LEFT button on the remote.
Alternate between dierent parts of a certain test by pushing the RIGHT button,
which will change the digits to let you know what part of bObi is being tested.
To Next Page
Loading...
