bObsweep bObi - Page 50

Test bObi’s oor detecting sensors
Remove bObi’s side brush before testing her oor sensors.
bObi’s oor detection sensors are the rst item tested when bObi is put into test
mode. In this test mode, numbers 1-6 located on top of the remote represent bO-
bi’s 4 infrared oor detection sensors and the two oor detection sensors located in
bObi’s left and right wheels. The test mode indicator reads 0000.
With bObi on the oor, numbers 1, 2, 3, and 4 should be underlined to show that
bObi’s oor detection sensors are working.
When you lift bObi up, the lines under numbers 1,2,3, and 4 will disappear and new
ones will show up underneath the numbers 5 and 6. This means that the left and
right wheels are o the oor, and oor detection sensors are working properly.
bObi’s rmware version
After testing the oor detection sensors, and while in test mode 0000, press LEFT
on the remote. The number 0001 will appear on the test mode indicator. The main
4-digit number on the screen indicates the rmware version of your bObi.