23
The domiflex model series (domiflex, domiflex low, domiflex low 20/80, domiflex low
classic, domiflex 185) becomes operational
1. Before you begin with the assembly, all packaging residues (incl. the cable ties) must be
completely removed. Remove the two screws that secure the lying surface on the
transport system.
2. Remove the two lying surface parts from the transport system, push them together and
screw them tightly on both sides with the screws previously removed. Hook in the motor
in such a way that the connection sockets point towards the centre of the bed and close
by means of closing caps.
3. Push one end piece on one side completely and screw tight.
4. Push on the second end piece only up to directly in front of the threaded hole.
To Next Page
Loading...