34
5.3 Mattresses
In general, foam and latex mattresses are suitable for the Hermann Bock nursing care
beds. A volumetric weight of at least 35 kg/m3 is required along with the dimensions of
90 x 190 cm, 100 x 190 cm, 90 x 200 cm and 100 x 200 cm.
The height of the mattress used may not exceed:
- 15 cm for aluminium or springwood lying surfaces and
- 12 cm for lying surfaces with spring systems
.
For higher mattresses, an additional attachment
guard device must be used, which is available as an
accessory. When using foam mattresses, we rec-
ommended the use of a cut foam mattress to allow
a better combination with the lying surface.
Hazard note from Bock
For safety reasons use only original Bock accessories when furnishing your nursing care bed fur-
ther. Those accessories must be approved by Hermann Bock for the respective bed model. A
detailed overview of the accessories and extras for your bed can be found on a separate data
sheet. Hermann Bock assumes no liability for accidents, damages and hazards arising from the
use of other accessories!
To Next Page
Loading...