28
– Place the power cable in a way that it will not be rolled over or strained during
the operation of the bed or could be damaged when inserting the mains plug
again.
4.4 Transport, storage and operating conditions
4.5 Function notes
To fix the bed in place, the brakes on the castors (if
any) of the chassis must be locked. To accomplish
this, use your foot to move the locking lever on the
chassis downwards.
If necessary, pull the integrated side rails up until
they lock into place. When using mattresses of dif-
ferent thickness, the minimum height of 22 cm,
measured from the top edge of the side rail above
the mattress without compression, may not be underrun (additionally, a third attachment
guard must be used).
4.6 Disposal
Each of the components made of plastic, metal and wood are recyclable and can be dis-
posed/recycled in compliance with the relevant legal provisions. Please note that electric
adjustable nursing care beds or nursing beds are considered commercially used electronic
scrap according to the WEEE-EC directive 2012/19/EC (b2b). All replaced electrical and
electronic components of the electrical adjustment system must be handled in accord-
ance with the requirements of the Electrical and Electronic Equipment Act (ElektroG) and
disposed of properly.
To Next Page
Loading...