Body Solid EXM1 - Assembly Step 2 A; Place Weight Stack Raisers F and Rubber Donuts 29 onto Rear Leg B; Slide Weight Stack Plates 36 onto Guide Rods G

22
STEP
2A
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of
At this point make sure that the gym is in the right location.
1. Place two Weight Stack Raisers F and two Rubber Donuts 29 onto Rear Leg B as shown.
Slide two Guide Rods G through the Rubber Donuts 29 and through the two Weight Stack
Raisers F and into the Rear Leg B.
NOTE:
Use Weight Stack Raiser (F) for a 160lb. weight stack.
Do NOT use Weight Stack Raiser (F) for a 210lb. weight stack.
2. Slide Weight Stack Plates 36 onto Guide Rods G. Make sure the opening in each Weight
Stack Plates 36, for the Weight Stack Pin 30, is facing forward.
NOTE:
Use fteen 10lb. plates for a 160lb. weight stack.
Use twenty 10lb. plates for a 210lb. weight stack.
STEP
3