46
N
Right Pec Dec Arm
d18
d25
Pec Dec Cable
1
2
3
STEP
8.1
Attach one end of the Pec Dec Cable d25 into the Right Pec Dec Arm N. Route the Pec Dec Cable
d25 over the top of Pulley and under Pulley Cable Guide d18 as shown.
Route the Pec Dec Cable d25 down and through Small Pulley Holder W, and install the Pulley
into the Small Pulley Holder W as shown using:
(1) a8 3/8” x 1 1/2” hex head bolt
(1) b2 3/8” nylon locking nut
Route the Pec Dec Cable d25 up from the Small Pulley Holder W, over the top of Pulley
and under Pulley Cable Guide d18.
Attach this end of the Pec Dec Cable d25 into the Left Pec Dec Arm O.
NOTE:
At this point you should now wrench tighten all bolts and nuts on this step.
O
Left Pec
Dec Ar
m
b2
d6
a8
W
Small Pulley
Holder
1
2
3
2
NOTE:
Remove nger tightened pulleys as needed. Do Not wrench tighten until the
cables are installed.
To Next Page
Loading...
