Body Solid EXM2500 - Cable Adjustments and Tensioning; Weight Stack and Pulley Adjustments

54
Cable Adjustments
M
Weight Stack Top
U2
Double Pulley Holder
Cables can stretch slightly when your gym is rst used. If there is slack in the cables before resistance is
felt, the cables should be tightened. Cable tension can be adjusted in several ways:
Move the pulley up or down in Weight Stack Top M
Move the pulley up or down in Double Pulley Holder U2
Adjust the chain attached to the Main Base Frame A
Adjust the chain attached to the Small Pulley Holder W
To adjust your cables see the illustrations below. Do not over tighten the cables. If the cables are over
tightened you will notice the Top Plate d29 will be lifted off the weight stack.
First, remove the Weight Stack Pin a13 from the Weight Stack. This will release tension on the cables.
You can now remove the pulley inside Weight Stack Top M and move the pulley up or down to adjust the
cable tension.
First, remove the Weight Stack Pin a13 from the Weight Stack. This will release tension on the cables.
You can now remove the lower pulley inside Double Pulley Holder U2 and move the pulley up or down to
adjust the cable tension.
D
2” x 4” Upright
b2
d6
a8
d6
a8
b2