The data has now automatically been saved and stored enabling both input and
output subject data to be recalled later.
The electrodes and leads may at this stage be removed.
The next screen that is automatically displayed is dependent on how the
operator has set up the user selectable DISPLAY OPTIONS (refer
INSTALLATION MODE, page 14 ) as defined in that section.
REPEATING A MEASUREMENT
In the event that you wish to repeat a measurement and provided that the unit
is not switched OFF, it will hold the previous input data in its memory. This will
allow a quick re-test or simple amendment to an incorrectly keyed in parameter.
Once the unit is switched off, it will revert to the default settings.
The user can select to change the default settings, refer to INSTALLATION
MODE (OPTIONS). This facility is useful if the same subject is being constantly
measured over a period of time. This will allow the testing to be performed
quickly, saving time for maximum operational efficiency.
To Next Page
Loading...
