13
engine.
Please don’t use this feature while car/vehicle with high-speed driving, and we suggest connect relay with
fuel control line in your car, Bofan is not liable for any traffic accidents.
Buzzer:
9 Sending SMS command 000000OPC1,1 to tracker to trigger buzzer for one time
9 It also can be set to automatically triggered by other alarms
For example, Speed Alarm Î Buzzer keeps working for 10 seconds,
z First you need to set Speed Alarm (both are ok by SMS or in FMS)
z Second sending two SMS commands 000000AN1'#OPC1,1,',10,'#OPC1,0' and
000000SALSPD10001 to tracker.
Note:
the fifth parameter in SALSPD is for the AN command number, AN1 Î 1 at fifth parameter, AN2
Î 2 at fifth parameter, parameter 1
st
to 4
th
details, please refer to command list.
6. SMS Commands List
Note: the device password is 000000 as default
Get tracker firmware version
Command
<password>VER
Remarks VER=Version
For example: 000000VER
Get current location
Command
<password>RCP
Remarks Get current location’s latitude and longitude of PT502
Get Google map link by SMS request
Command
<password>RCM
Remarks This command is still valid even don’t configure PT502’s GPRS connecting
Change password
Command
<password>PWD<new password>
Remarks PWD=Password (must be 6 digits)
Reset password when the previous password is forgotten
Command
000000RPW<new password>
Remarks Please long press the SOS button when you send this command to PT502
(new password must be 6 digits)
Set preset phone number for SOS button
Command
<password>SOS,<SOSNumber1>,<SOSNumber2>,<SOSNumber3>
Remarks z SOS Number: Preset phone number to receive phone call or SMS from PT502. Max 16
digits. Maximum 3 SOS numbers can be set.
z If only set the 1st number, PT502 will send SMS and then call to this first number after
pressing SOS button.
To Next Page
Loading...
