14
z If set the 2nd or 3rd numbers too, PT502 will send SMS to all 3 numbers, only call to the
1
st
number after press SOS button.
Note:
<password>SOS, command is for cancel all pre set numbers.
Set Over Speed Alert
Command
<password>SPD<Max Speed>
Remarks Max Speed (the preset speed value)
z =0 to turn off this function
z =[0,500](unit: Km/h)
Example: 000000SPD80 it will send alert when it is over 80Km/h
NOTE
When car speed is higher than the preset value, PT502 will send an alert SMS to the preset
SOS number.
Set Geo-fence Alert
Command
<password>GOF<Type>,<SWLat>,<SWLng>,<NELat>,<NELng>
Remarks z Type =1, alert when out of range
z Type=2, alert when enter this range
z SW=South-West
z NE=North-East
Example：000000GOF0, to turn off this function
NOTE
When car leaves out or enters a preset scope, PT600 will send one Geo-fence SMS to the
preset SOS number.
Set Mileage Alert
Command
<password>MLA<base mileage>,<increment>
NOTE
This Mileage Alert can be sent to your mobile by SMS if you set your mobile number as SOS
number into this tracker installed in car and it also can be sent to your email address if you
set your email address in software successfully.
Example
000000MLA100000,50000
This example means, if the tracker records the car driving more than 10000km, tracker will
send one Mileage Alert for each 5000km mileage increments.
Set Odometer
Command
<password>SOD
Remarks unit: 100 meters
Example
000000SOD or 000000SOD0: it is to set the tracker’s odometer to be “0”
000000SOD100: it is to set the tracker’s odometer to be 10km.
(100*100meter=10000m=10km)
000000SOD5000: it is to set the tracker’s odometer to be
500km.(5000*100=500000m=500km)
Set time zone for tracker
Command
<password>TMZ<Time>
Remarks Time from -13 to 13
Example
000000TMZ8 for set China time zone
NOTE
After setting time zone into tracker, you can get your local time in tracker reply message.
Restart
Command
<password>RST<Type>
Remarks z Type=0 or null, to reboot PT502
z Type=1 to reboot GPS
To Next Page
Loading...
