15
z Type=2 to reboot GSM
Reset PT502 to default
Command
<password>DFT
Remarks DFT=Default
Request Power
Command
<password>RPO
Remarks RPO=Request Power Voltage
Cut Power Alarm
Command
<password>CPA<Value>
Remarks z Value=0 to disable Cut Power Alarm
z Value=1 to enable Cut Power Alarm
z Default set: 000000CPA1
Get IMEI
Command
<password>IME
Remarks To get tracker’s IMEI number
Note:
IMEI number can’t be tracker ID number.
Output Control
Command
<password>OPC1,<Action>
Remarks Action
z =0 to close the output
z =1 to open the output
Set Alarm Action
Command
<password>AN<Index1>’#<Index2>,’,<Index3>,’#<Index4>’
Remarks Index1= 1 mean NO.1 Action. (it can be 1-5)
Index2=OPC1,1 means trigger output1 on
NOTE:
any other command can be done at here)
Index3=Time (Unit: second)
If you want to automatically close the above alarm or trigger another alarm in few
seconds, please input the time at index3, and also input next close alarm command
at index4.
NOTE:
Any other command can be done at here)
Index4=OPC1,0 means close output
NOTE:
Any other command can be used at index4
Set Alarm
Command
<password>SAL<Alarm type><Index1><Index2>
Remarks Alarm type =IN1/IN4/SPD/GEO/MLA/SKA/LPA/IU1/IU4
Index1=1, to alert on platform
=0, do not alert on platform
Index2=1, to send alert SMS
=0, do not send alert SMS
Default set:
000000SALIN111
000000SALIN400
AD alarm
Command
<password>AD1<index1> <Parameter>,<alarm name>,<index2>
To Next Page
Loading...
