12
3.2 Prior to use
Please make sure that the contacting surface for the magnet is level, clean and rust-free.
Remove any varnish or primer. When working on materials that are not magnetisable,
suitable fixation devices, obtainable as accessories, e.g. suction plate, vacuum plate or pipe-
drilling device must be used. When work on steel materials with a material thickness of less
than 5 mm, the work piece must be reinforced with an additional steel plate in order to
guarantee the magnetic holding power.
Check the machine for possible damage; Before using the machine, you must carefully
check protective devices or slightly damaged components to ensure they are operating
perfectly and as intended. Check that moving are in perfect working order and do not jam
and check whether parts are damaged. All parts must be correctly installed and fulfill all
conditions necessary to ensure perfect operation of the machine. Damaged protective
devices and parts must be repaired or replaced according to specifications by the dealer.
DO NOT use under wet conditions or in presence of flammable liquids or gases. This
magnetic drilling machine is a professional power tool.
DO NOT let children come into contact with the machine. Supervision is required when
inexperienced operators use this machine.
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only. Always check that the power
supply corresponds to the voltage on the rating plate.
Your magnetic drilling machine is designed in class I (grounded) according to EN 61029-1.
Earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the service organisation.
EXTENSION CABLE
If an extension cable is required, use an approved 3-core extension cable suitable for the
power input of this tool (see technical data).The minimum conductor size is 1.5 mm² (for
220V) or 14 AWG (Amperage Wire Gauge for 110V). The maximum length is 30 metre
(± 100 ft).
WARNING: When using a reel, always unwind the cable completely!
TRY A FEW SIMPLE PROJECTS USING SCRAP MATERIAL UNTIL YOU DEVELOP A
“FEEL” FOR THE MACHINE.
LET THE MACHINE RUN IN FOR A PERIOD OF 8-10 HOURS BEFORE STARTING WITH
BIG OPERATIONS. DO NOT LOAD THE MACHINE TOO MUCH DURING RUN-IN
PERIOD.
NEVER USE THE MACHINE IN SERIOUS OVERLOAD.
KEEP THE MACHINE CLEAR FROM MOISTURE AT ALL TIMES TO PROTECT THE
MACHINE, YOURSELF AND OTHERS.
To Next Page
Loading...