5
Personal safety
1. Stay alert, watch what you are doing and use common sense when using a magnetic
drilling machine. Do not use the machine while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating a magnetic drilling
machine may result in serious personal injury;
2. Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewelry or long hair can be caught in
moving parts;
3. Avoid accidental starting. Be sure the switch is off before plugging the machine in.
Carrying a magnetic drilling machine with your finger on the switch or plugging in a
magnetic drilling machine that has the switch on increases the change of accidents;
4. Never place hands, fingers, gloves or clothing near drilling area or rotating machine
parts;
5. Remove adjusting keys or switches before turning the machine on. A wrench or a key
that is left attached to a rotating part of the machine may result in personal injury;
6. Do not overreach. Keep proper footing and balance at all times. Proper footing and
balance enables better control of the magnetic drilling machine in unexpected
situations;
7. Use safety equipment. Always wear eye protection. Dust mask, non-skid safety
shoes, hard hat and hearing protection must be used for optimal safety;
8. Always use supplied safety chain during any work on non-horizontal surfaces.
Magnetic drilling machine can release from surface.
WARNING: Wear ear and eye protection when using this machine.
Machine use and care
1. When using the machine on non-horizontal surfaces, you must use cutting paste. Do
not use oil because the oil can drip into the motor unit;
2. While operating the machine, the annular cutter must be cooled and lubricated with
high quality cutting lubricants;
3. Always remove the slug from the annular cutter after each hole.
WARNING: The metal slug can be sharp and very hot!
4. Use clamps or other practical solutions to secure and support the workpiece to a
stable platform. Holding the workpiece by hand or against your body is unstable and
may lead to loss of control;
5. Do not use the machine when the switch does not turn it on or off. Any machine that
cannot be controlled with the switch is dangerous and must be repaired;
6. Disconnect the plug from the power source before making any adjustments, changing
accessories or storing the tool. Such preventive safety measures reduce the risk of
starting the tool accidentally;
7. Store your magnetic drilling machine out of reach for children and other untrained
persons. Tools are dangerous in the hands of untrained users;
8. Maintain your machine with care. Keep cutting tools sharp and clean. Properly
maintained tools, with sharp cutting edges are less likely to break and are easier to
control;
9. Check for misalignment of moving parts, breakage of parts and any other condition
that may affect the machine’s operation. If you detect damage have the machine
serviced before use. Many accidents are caused by poorly maintained tools;
To Next Page
Loading...