16
English
3 - Use
The device can be used in all positions, carried by hand or suspended.
Procedure for use
• Install the battery
• Switch the device on, by pulsing
on the main trigger
• Position the Rivet Nut
®
on the mandrel. A light pressure starts the motor and causes the
automatic screwing of the Rivet Nut
®
, then the shutdown (Push-Pull system). Then insert
the Rivet Nut
®
into the hole.
• Alternatively, insert the Rivet Nut
®
into the hole, then push the mandrel against it in order
to activate the push-pull.
• Press the trigger and hold it until the mandrel has gone outside from the Rivet Nut
®
thread.K
KEEP THE TRIGGER PRESSED FOR THE ENTIRE DURATION OF THE CYCLE.
IF THE TRIGGER IS RELEASED, THE INSERTION IS NOT CORRECT
Push pull (automatic) Insert Crimp Spin off (automatic)
Unscrew button
• If unscrewing is difficult, use the CENTER (UNSCREW / RESET)
button.
To unscrew,
hold
the
button
down
until the mandrel has fully gone outside from the Rivet
Nut
®
thread.K
Call Cardinal Components to Order or for a Quote
800-236-3200 - sales@rivetnutusa.com - www.rivetnutusa.com
To Next Page
Loading...
