25
English
6 - Troubleshooting
Problem
The screwing by push
pull is not working
correctly
The Push pull sensor has to be calibrated
Damaged mandrel threading
Switch off the battery and install it again
Replace the mandrel following the
instructions
Problem in the motor
Check the motor idle rotation pressing
the Reset button
The setting cycle is not
proceeding
The setting conditions are not fullfilled
The quality of the
setting is not correct
The automatic
unscrewing is not
proceeding
The display screen
doesn't turn on
The Rivet Nut
®
thread is
damaged
after setting
The bulge of the Rivet Nut
®
is
not well formed
The Rivet Nut
®
head is not in contact
against
the support after setting
The Rivet Nut
®
turns on the support
The Rivet Nut
®
head is not in contact
against
the support after setting
The hydraulic pressure has not been
reached.
Rivet Nut
®
tapping or threading of
the damaged draw mandrel.
Problem in the motor.
The battery is discharged
The tool remains unuse several hours
• Ensure that the Push pull screwing has
been done
• Change the condition for alowing the
setting launch
• Adjust the position of the anvil following
the instructions.
• Excessive setting force.
Check the setting
force value range in the catalogue of the
Rivet Nut
®
• Damaged mandrel threading. Replace the
mandrel following the instructions.
• Thickness incompatible with the Rivet
Nut
®
• The hydraulic pressure has not been
reached. Fill oil, following the instructions
Make sure the Rivet Nut
®
is push against
the support while setting
• Setting force is too low. Check the setting
force value range in the catalogue of the
Rivet Nut
®
.
• Repeat the setting test following
the instructions.
Make sure the Rivet Nut
®
is push against
the support while setting
Fill oil, following the instructions Replace
the mandrel following
the instructions.
Check the motor idle rotation pressing the
Reset button
Replace the battery by a loaded one
Unplug
the battery and place it againR
Possible causes Solution
Call Cardinal Components to Order or for a Quote
800-236-3200 - sales@rivetnutusa.com - www.rivetnutusa.com
To Next Page
Loading...
