Boly Trail Camera-SG520
mode, and the camera will take photos at the given
time interval. NOTE: If the PIR Trigger is set to off,
then Time Lapse can’t be set to off.
Default: OFF
Choose the sensitivity of PIR. The higher the
sensitivity, the more easily the motion sensor will be
triggered. It is recommended to use Normal mode.
The sensitivity of the PIR is dependent on the
temperature. A higher temperature leads to lower
sensitivity.
Default: Normal
This parameter means how long the PIR sensor will
be inactive after it is triggered in hunting mode.
During this time the PIR of the device will not react
to any motion.
Default: 10 Sec
In hunting mode, when the SD card is full, the first
images or videos will be replaced by new pictures or
videos, so you don't need to retrieve your memory
card manually. But in SETUP mode, the SD card
can’t recycle storage.
Default: On
Deletes all images and videos in the SD card. Make
sure you have made a backup of important data
before selecting this option.
Contains version information.
Restore all camera settings to default values.
To Next Page
Loading...
