Bomag BW 900-2 - Page 32

Operation
BOMAG 32 BW 900-2
Fig. 30
l Turn the ignition key (Fig. 30) to position "I".
!
Caution
Do not attempt to start for longer than 20 sec-
onds without interruption, but interrupt the
starting process for a minute.
If the engine has not started after two attempts
perform troubleshooting.
Fig. 31
l Turn the ignition key (Fig. 31) to position "II",
the starter will crank the engine.
l As soon as the engine ignites return the igni-
tionkeytoposition"I".
Fig. 32
l If the vibration starts to run after starting the
engine, press the vibration push button (Fig.
32) immediately to switch the vibration off.
Fig. 33
l Open the choke (Fig. 33) slowly.
!
Caution
Run the engine warm for a short while, but do
not run with idle speed for more than 10 min-
utes.