Bomag BW 900-2 - Switching the Vibration on or off; Fig. 39

Operation
BOMAG 35 BW 900-2
4.7 Switching the vibration on
or off
!
Danger
Danger of damage!
When compacting with vibration you must al-
ways check the effect of vibration on nearby
buildings and underground supply lines (gas,
water, sewage, electric power) and stop com-
paction work with vibration, if necessary.
!
Caution
Risk of bearing damage!
Donotswitchthevibrationononhard(frozen,
concrete) ground.
i
Note
Switch the vibration on when the engine is running
with full speed.
Vibration at standstill leaves transverse marks in
the asphalt, therefore:
l only switch the vibration on after shifting the
travel lever to the desired travel direction.
l switch the vibration off before stopping the ma-
chine.
Switching the vibration on
Fig. 39
l Always shift the throttle lever (Fig. 39) to posi-
tion "MAX".
Fig. 40
l Move the travel lever (Fig. 40) slowly to the de-
sired travel direction.
Fig. 41
l Actuate the vibration push button (Fig. 41).
Switching the vibration off
Fig. 42
l Actuate the vibration push button (Fig. 42)
again.