BOMANN WA 5721 - Electrical Connection; Startup and First Use; Preparation for First-Time Operation

10
• Always make sure that the ho
se is not bent or
squeezed.
Use for example a hose retaining sheet
(a) (not included).
•
The hose must be installed at a height of min.
850 mm and max. 1250
mm above the floor.
• Secure the hose securely
in order
change in position and with it a
water leakage.
Electrical connection
Electrical connectionElectrical connection
Electrical connection
WARNING:
WARNING:WARNING:
WARNING:
•
The installation to the mains supply must conform to the local standards and regul
tions.
• Improper connection may cause to an electric shock
electric shockelectric shock
electric shock!
• Do not use multiple sockets or extension cords.
• It is not allowed to modify the plug provided with the appliance!
If the plug does not
fit properly to the outlet, let install a proper outlet by an authorized specialist.
•
The accessibility of the power plug must always be ensured in order to disconnect
the device from the power supply in case of an emergency.
•
Make sure that the voltage supply matches the specifications on the rating label
before connecting.
•
Connect the mains cable to a properly installed and earthed wall outlet.
• If the plug after installation is
not accessible, a corresponding disconnect device
must be available to meet the relevant safety regulations.
Startup / Operation
Startup / OperationStartup / Operation
Startup / Operation
Prior using for the first t
Prior using for the first tPrior using for the first t
Prior using for the first time
imeime
ime
• Make sure that all transport securing devices has been removed.
• Remove the accessories and any material from the drum.
• Allow the appliance to wash the
first time without any laundry, with the addition of
some washing agent in the program [Drum Clean] (see "
Starting the appliance
se is not bent or
Use for example a hose retaining sheet
The hose must be installed at a height of min.
mm above the floor.
in order
to avoid a
water leakage.
The installation to the mains supply must conform to the local standards and regul
a-
If the plug does not
fit properly to the outlet, let install a proper outlet by an authorized specialist.
The accessibility of the power plug must always be ensured in order to disconnect
Make sure that the voltage supply matches the specifications on the rating label
Connect the mains cable to a properly installed and earthed wall outlet.
not accessible, a corresponding disconnect device
first time without any laundry, with the addition of
Starting the appliance
").