BOMANN WA 5721 - Installation; Transport Locking Screw Removal; Installation Location Criteria

7
Installation
InstallationInstallation
Installation
WARNING:
WARNING:WARNING:
WARNING:
The unit must not be connected to the mains during installing. Otherwise there is
ger to life
ger to lifeger to life
ger to life or electric shock hazard
electric shock hazardelectric shock hazard
electric shock hazard!
CAUTION:
CAUTION:CAUTION:
CAUTION:
For a correct operation
the appliance must be connected properly. The specifications
for water supply and drain as well as the electrical connection must fulfill the required
criteria.
Remove the transport locking
Remove the transport locking Remove the transport locking
Remove the transport locking screws
screwsscrews
screws
CAUTION:
CAUTION:CAUTION:
CAUTION:
• Before using, all transport locking screws
must be removed from the
back. Otherwise it may cause serious damages.
• Keep the transport
locking screws for later use / transport. Never transport the
appliance without properly attached transportation safety!
• Loosen and remove the four transport locking screws with
the supplied
• Insert the pre-installed transport locking covers at the unit back.
Installation location
Installation locationInstallation location
Installation location
•
The site should be located near the water inlet and outlet, as well as near a properly
grounded power socket.
•
Good ventilation around the appliance is required, in order to dissipate the heat
properly. Sufficient clearance must be created for this purpose.
• The clearance to the front must be created so,
that the appliance door can open
without being impeded.
• Make sure that the floor on which the appliance is installed, is
even,
and clean.
The unit must not be connected to the mains during installing. Otherwise there is
da
dada
dan-
n-n-
n-
the appliance must be connected properly. The specifications
for water supply and drain as well as the electrical connection must fulfill the required
must be removed from the
appliance
locking screws for later use / transport. Never transport the
the supplied
wrench.
The site should be located near the water inlet and outlet, as well as near a properly
Good ventilation around the appliance is required, in order to dissipate the heat
that the appliance door can open
even,
heat-resistant