EN
Bona Edge UX
13
Starting Machine Description (Cont.)
The disc does not stop immediately! Take care not to touch it
with any part of the body during this phase.
A safety sensor is tted to the machine. If the machine is too
inclined the motor stops. To recommence sanding repeat the
start-up operations described above.
Raise the disc so that the
machine is only resting on
the oor with its wheels.
Press one of red starting
lever and then press the
contact switch on the upper
black shell of machine.
6. 7.
To stop the machine, raise the
disc so that the machine is
only resting on the oor with its
wheels. Then release both red
starting lever.
Keep the machine moving
when the abrasive disc is
lowered and put on the work
surface.
Starting the machine (Cont.)
Allow the motor to "rest" during periods of heavier use.
5.
To Next Page
Loading...
