Bona Edge UX
12
Starting Machine Description
Machine use
Working method
The machine is intended for the edge sanding of wooden oors. It may be used on newly laid and untreated oors and existing
oors that have been treated with lacquer or oil.
The main function of the machine is to serve as a complement to a belt or a drum sander for sanding edges.
The machine has been thoroughly checked and approved before leaving the factory.
When sanding, hold the machine, use both handles and move the machine in circles in the direction of rotation over the surface
which is to be sanded. It is important that the machine rests on three points, both the wheels and the sanding disc.
The best result is obtained by letting the machine work with its own weight.
When using ne abrasives you must be careful not to make any burn marks due to high friction created.
In addition to the points noted the sanding must be adapted to the type, pattern and composition of the oor.
Starting the machine
Become familiar with
the machine and read all
instructions and safety
notices. Ensure that all
operators read this manual.
1.
Use a remote control industrial vacuum cleaner intended for wooden dust (maximum length
of pipe: 10 m - pipe diameter: 38 mm). As an alternative, x the bag by tying the cord over the
suction elbow ange.
2.
Fit the disc in accordance
with the 'Abrasive Assembly
Procedures' (pg.14).
3. 4.
Locate the power supply. The socket must be compatible
with the plug. To avoid electrical hazards the socket must be
grounded with a 16 A fuse. Connect the plug to the socket.
To Next Page
Loading...
