EasyManua.ls Logo

Bond BH65001-1 - User Manual

Bond BH65001-1
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DANGER
WARNING
FIRE OR EXPLOSION HAZARD
If you smell gas:
Shut off gas to the appliance.
Extinguish any open flame.
If odor continues, leave the area immediately.
After leaving the area, call your gas supplier
or fire department.
Failure to follow these instructions could
result in fire or explosion, which could cause
property damage, personal injury, or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance. An LP-cylinder not connected
for use shall not be stored in the vicinity of
this or any other appliance.
DANGER
CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed
space such as a camper, tent, car or
home.
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
WARNING
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury, or loss of life.
or the gas supplier.
by a qualified installer, service agency,
Installation and service must be performed
WARNING:
For Outdoor Use Only.
service agency, or the gas supplier.
with this appliance. Installation and service must be performed by a qualified installer,
damage, personal injury or loss of life. Refer to the owner's information manual provided
Improper installation, adjustment, alteration, service or maintenance can cause property
Model# BH65001-1
Item# 52265
YORKFORD HALF-MOON EXTERIOR GAS FIRE PIT
User Guide

Other manuals for Bond BH65001-1

Questions and Answers

  • T
    timothy99Aug 10, 2025
    What to do if my Bond Outdoor Fireplace heating unit won’t light?
    • K
      Kayla HernandezAug 10, 2025
      If your Bond Outdoor Fireplace heating unit won’t light, there are several possible causes: * The igniter pin may be broken. * The electrode wire might be loose or disconnected; reconnect the wire to the igniter box located inside the fire pit behind the igniter box. * The electrode wire could be shorting between the valve and igniter pin. * There may be no gas flow; check that the gas tank isn’t empty. * The regulator isn’t securely connected to the tank; tighten the regulator connection to the gas tank. For broken igniter pins or electrode wires shorting, contact Bond Manufacturing Co., Inc. for a replacement part.
  • T
    Taylor NguyenAug 15, 2025
    Why does my Bond BH65001-1 Outdoor Fireplace heating unit emit a lot of black smoke?
    • R
      Richard MartinezAug 15, 2025
      Your Bond Outdoor Fireplace might emit black smoke due to a few reasons: * The flame is obstructed at the burner ports; ensure all burner ports are free of lava rocks, pumice stones, or Lava-Glass® pieces. * The regulator hose is kinked; straighten any bends or kinks in the hose. * There is no gas flow; verify that the gas tank isn't empty.
  • J
    James MurrayAug 20, 2025
    What to do if my Bond BH65001-1 has a sudden drop in gas flow?
    • C
      Cameron GrantAug 20, 2025
      If you experience a sudden drop in gas flow in your Bond Outdoor Fireplace, it could be due to: * Activation of the excess flow safety valve. To resolve this, turn the control knob to the ‘off’ position, close the tank valve, and disconnect the propane gas tank. Then, turn the control knob to ‘high’ and wait 1 minute. After waiting, turn the control knob back to the ‘off’ position and reconnect the propane gas tank. Then light the fire unit. * High or gusting winds. If this is the case, increase the flame to ‘high’.
  • A
    Annette DixonAug 26, 2025
    What to do if the flame blows out easily on my Bond Outdoor Fireplace?
    • K
      kennedycurtisAug 26, 2025
      If the flame on your Bond Outdoor Fireplace blows out easily, it could be due to: * No gas flow; check that the gas tank isn’t empty. * The excess flow safety valve has been activated; follow the instructions for a sudden drop in gas flow.
  • E
    Edward PerezAug 30, 2025
    How to fix clogged burner ports on my Bond Outdoor Fireplace?
    • A
      Andrew OconnorAug 30, 2025
      If the burner ports on your Bond Outdoor Fireplace are clogged, turn off all gas flow connections. Then, insert an opened paperclip (or similar item) into each of the burner ports to clear them out.
  • M
    Michael ChandlerSep 3, 2025
    What to do if the igniter pin and burner are wet on my Bond BH65001-1 Outdoor Fireplace?
    • S
      seth63Sep 4, 2025
      If the igniter pin and burner are wet on your Bond Outdoor Fireplace, dry them off with a soft cloth.

Bond BH65001-1 Specifications

General IconGeneral
BrandBond
ModelBH65001-1
CategoryOutdoor Fireplace
LanguageEnglish

Related product manuals