Bond 52095 - User Manual

Questions and Answers

M
Matthew HarrisJul 29, 2025
Why won't my Bond Outdoor Fireplace light?
- T
  Tina GouldJul 29, 2025
  There are several possible reasons why your Bond Outdoor Fireplace won't light. It could be due to: * A broken igniter pin (contact Bond Manufacturing Co.,Inc. for a replacement part). * A loose or disconnected electrode wire (reconnect it to the igniter box inside the table behind the igniter box). * The electrode wire shorting between the valve and igniter pin (contact Bond Manufacturing Co.,Inc. for a replacement part). * No gas flow (check that the gas tank isn’t empty). * The regulator not being securely connected to the tank (tighten the regulator connection to the gas tank).
J
Joann DavisAug 2, 2025
Why does my Bond 52095 emit black smoke?
- B
  Brian CharlesAug 2, 2025
  Your Bond Outdoor Fireplace might be emitting black smoke due to a few reasons: * The flame could be obstructed at the burner ports (ensure all burner ports are free of lava rocks, pumice stones, or LavaGlass® pieces). * The regulator hose may be kinked (straighten any bends or kinks in the hose). * There may be no gas flow (verify that the gas tank isn’t empty).
N
Nancy AndersonAug 8, 2025
What to do if there is a sudden drop in gas flow in my Bond 52095?
- A
  Anna Curtis MDAug 8, 2025
  If you experience a sudden drop in gas flow with your Bond Outdoor Fireplace, it could be due to: * Activation of the excess flow safety valve. To resolve this: 1. Turn the control knob to the ‘off’ position. 2. Close the tank valve and disconnect the propane gas tank. 3. Turn the control knob to ‘high’ and wait 1 minute. 4. Turn the control knob back to the ‘off’ position. 5. Reconnect the propane gas tank. 6. Light the fire unit as indicated in the ‘To Light’ section of this manual. * High or gusting winds, in which case you should increase the flame to ‘high’.
L
laura74Aug 12, 2025
Why does the flame blow out easily on my Bond 52095 Outdoor Fireplace?
- N
  nathaniel38Aug 12, 2025
  The flame on your Bond Outdoor Fireplace might be blowing out easily because: * There is no gas flow, so check that the gas tank isn’t empty. * The excess flow safety valve has been activated. See the ‘sudden drop in gas flow’ section for instructions.
C
Charles SuarezAug 17, 2025
How to fix clogged burner ports on Bond 52095?
- J
  Jessica BrownAug 18, 2025
  If you suspect clogged burner ports on your Bond Outdoor Fireplace, turn off all gas flow connections. Then, insert an opened paperclip (or similar item) into each of the burner ports to clear them out.
B
boydelizabethAug 23, 2025
What to do if igniter pin and burner are wet in my Bond 52095 Outdoor Fireplace?
- S
  Savannah MccannAug 23, 2025
  If the igniter pin and burner of your Bond Outdoor Fireplace are wet, dry them off with a soft cloth.