Boneco H300 Manual

13
en
MANUAL HANDLING
ABOUT MANUAL HANDLING
Manual handling works conveniently by the knob
on the front side. The BONECO app o ers additional
extensive options for control and automation of the
BONECO appliance.
AUTO MODE
If you have never operated the BONECO appliance
with the BONECO app and switch it on for the fi rst
time, it starts up in AUTO mode. The appliance is pre-
set to a target relative humidity of 50 percent. The
performance level is automatically adapted to the
current humidity: The drier the air, the higher the
performance level.
If the preset target humidity is exceeded, the appli-
ance switches to standby mode, which is indicated
by the pulsing LED:
If the humidity drops below the set level, the appli-
ance resumes operation.
ADJUSTED AUTO MODE
If you have already operated the appliance with the
BONECO app and set a di erent humidity, that value
is automatically taken over when the appliance is
switched on.
SWITCHING ON AND OFF
1. Briefl y press the knob once to switch on the ap-
pliance.
The appliance is always in AUTO mode when it is
switched on. You can identify active AUTO mode by
the small LED that lights up above the knob.
2. To switch o the appliance while it is in AUTO
mode, briefl y press the knob once.

Boneco H300 Specifications

General

Timer	Yes
Noise level	51 dB
Air purify rate	90 m³/h
Number of speeds	6
Water tank capacity	4.5 L
Suitable for room area up to	50 m²
AC input voltage	100 - 240 V
AC input frequency	50 / 60 Hz
Power consumption (max)	9.6 W
Power consumption (standby)	0.6 W
Placement	Floor
Product color	Black, White
Built-in display	No

Weight and Dimensions

Width	280 mm
Height	465 mm
Weight	5500 g