In the case of cleaning the drum and the water base in the dishwasher, a temperature of 130 °F (50 °C) may not be exceeded, as temperatures higher than this can cause
the plastic parts to deform.
RECOMMENDED CLEANING INTERVALS
Interval Action
After the third day without operation Empty water base and fill with fresh water
Every 2 weeks
Clean water base, drum and evaporator mat
Cleaning the pre-filter
Yearly Replace the AH300 POLLEN Filter
CLEANING IN THE DISHWASHER
PARTS NOT PERMITTED
The following parts cannot be cleaned in the dishwasher.
• Central part with filter cover
• Evaporator mat
• AH300 POLLEN Filter
WATER BASE AND DRUM
1. Remove the upper part of the BONECO H300.
2. Remove the drum with the evaporator mat.
3. Rotate both drum discs to loosen. In doing so, obserthe markings on the outer side of the disc.
4. Remove the evaporator mat from the drum.
5. With the exception of the central part, the AH300 POLLEN Filter, and the evaporator mat, clean all of the parts either by hand or in the dishwasher at max. the temperature of 130
°F (50 °C).
CLEANING THE EVAPORATOR MAT
ABOUT THE EVAPORATOR MAT
In the case of heavy contamination, the experience of limescale build-up of odor formation, the evaporator mat can be cleaned either by hand or in the washing machine. When
stretching the evaporator mat on the drum after cleaning, take note of correct positioning: