Boneco H300 User Manual

CLEANING IN THE WASHING MACHINE
The evaporator mat can be cleaned in the washing machine. Commercially available detergents can be used. For best results wash the evaporator mat by itself.
The evaporator mat may not be washed at a temperature higher than 104 °F (40 °C).
Do not dry the evaporator mat in the clothes dryer.
CLEANING BY HAND
1. Tumble the evaporator mat thoroughly in warm water so that the entire mat makes contact with some detergent.
2. Continue to rinse out the evaporator mat in clean and warm water until foam no longer forms.
CLEANING THE PRE-FILTER / REPLACING THE AH300 POLLEN FILTER
ABOUT THE PRE-FILTER
The pre-filter cleanses the air of coarse dirt particles to relieve the strain on the AH300 POLLEN Filter and to improve its effectiveness. Clean the pre-filter if it looks dusty or dirty.
1. Press down each of the four corners in sequence to unlock them.
2. Remove the pre-filter by pulling it upwards by the lug in its center.
3. Wash the pre-filter under running water using a cleaning brush.
4. Let the pre-filter dry before inserting it.
A damp pre-filter can impede the quality of the AH300 POLLEN Filter.
REPLACING THE AH300 POLLEN FILTER

Boneco H300 Specifications

General

Timer	Yes
Noise level	51 dB
Air purify rate	90 m³/h
Number of speeds	6
Water tank capacity	4.5 L
Suitable for room area up to	50 m²
AC input voltage	100 - 240 V
AC input frequency	50 / 60 Hz
Power consumption (max)	9.6 W
Power consumption (standby)	0.6 W
Placement	Floor
Product color	Black, White
Built-in display	No

Weight and Dimensions

Width	280 mm
Height	465 mm
Weight	5500 g