5
Insert the card into the top center of the feed opening. You can only cut up one credit card at the time.
Overloading
If you insert too much paper over the maximum shred capacity of the shredder, the indication light will be red
flashing, and the cutting unit will stop rotating. In this event, set the switch to “REV” to remove the paper. Reduce
the number of sheets and try again.
Overheating
If the shredder working continuously with exceeding the indicated maximum operating time of 10 minutes, there
is a possibility of the motor overheating. In this event, the indication light will be red, the cutting unit will stop. You
should therefore set the switch to the “AUTO” position and let the device cool down for about 45 minutes. The
device will be automatically disconnected from the power and will restart on its own once the motor has cooled
down sufficiently.
Troubleshooting:
Shredder will not operate
1. Make sure shredder is plugged into power source and the main power switch is switched on.
2. Make sure the waste bin is fully inserted into the shredder housing.
Paper jam
1. Switch to REV position and clear the jam
2. Switch to AUTO position to continue shredding.
CAUTION: Sharp cutter blades. Do not reach underneath the shredder head to remove jammed paper. Serious
injury can result.
This unit is equipped with anti-jam technology. The light will turn red indicating that the maximum sheet capacity
has been exceeded. Reduce the number of sheets and place the paper back into the paper feed slot.
Shredder stops while shredding
1. Shredder may have reached maximum duty cycle. Check if the light is turning flash red, when overheat,
please do not plug the unit, just wait about 45 minutes to continue with normal operation.
2. Shredder may be overloaded. If the overloading light keeps flashing red, please slide the switch to REV and
pull out the paper. Reduce the number of sheets and try again.
3. The wastebasket is possible full. Please empty it and place it back to the device properly, then try shredding
again.
Cutter Oiling Instructions
To ensure proper operation and function, periodic oiling of the cutting unit is required. Failure to oil your cutting
unit could result in reduced sheet capacity performance, excess noise, paper jams and possibly machine failure.
Oil your cutters every 5
th
or 6
th
time you empty the basket if excess squeaking and rubbing noise is coming from
the machine or if the shredders sheet capacity has diminished. Squeeze the lubricant across the full width of the
cutters or shred one piece of lubricant sheet accordingly. Touch the AUTO switch and insert paper to activate the
cutting unit forward for 3 seconds, then touch REV for 3 seconds again. Alternate between AUTO and REV at
least three times or until all paper scraps are cleared out.
To Next Page
Loading...
Need help?
General
