Bonsaii DocShred C237-B - Product Overview and Setup; Component Identification; Initial Setup; Operating the Shredder

1
3
2
4
5
6
1. Slide Switch: FWD/AUTO/OFF/REV
2. Power Light: Green
3. Overheat/Overload: Red/Flashing Red
4. Feed Slot for Paper &Credit Card
5. Handle
6. Transparent Window
Operaon instrucon:
C237-B will shred six(6)sheets of A4 size 75g/m paper maximumly at a single pass, and will accept paper
width up to 8.66 inches(220mm). When shredding small material like envelopes or receipts, insert them
through the middle of the feed opening.
1. Unpack the shredder. Place the shredder upright on a level surface.
2. Make sure the waste bin is properly inserted into the shredder cabinet.
3. Plug the power cord into a standard(120V)outlet. Do not use an extension cord.
Set up:
Operang the shredder :
AUTO:
REV:
OFF:
FWD:
Shredder c apacity:
2
The shredder will forward when slide the switch to this posion, and the "POWER" indicator light turns
green. If the paper jams when the switch is at AUTO posion, please slide the switch to FWD to shred
the paper through the slot.
3