18
Viewing Alarm Memory
After an alarm has been silenced and cleared from the display, you may
still review the points that were in alarm.
1. Ensure that the system is turned off (On light is off).
2. Press [4]. The following display shows that there are alarms in
memory:
ALARM MEMORY
HOLD 6 TO VIEW
3. Hold [6] to view those points which were in alarm. This
display shows that there was an alarm on Point 8:
ALARM PT 8
BEDROOM WINDOW
4. If you entered your passcode before the system dialed your
alarm company, the display shows:
CANCELED PT 8
BEDROOM WINDOW
5. Continue to hold [6] to view all points that were in alarm.
When the last alarm has been shown, the display shows:
TO CLEAR MEMORY
TURN SYSTEM ON
6. Turn the system on again to clear alarm memory.
To Next Page
Loading...
