Bosch 8 Series - Page 46

en Fault, what to do?
46
Fault code “:ƒ… is lit. Waste-water hose kinked or
blocked.
Install hose without kinks, remove any
residue.
Siphon connection still sealed. Check connection to siphon and open if
required.
Cover on the waste water pump
loose.
Lock cover correctly. ~ "Waste water
pump" on page 44
Fault code “:ƒ† is lit. Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Clean pump and lock cover correctly.
~ "Waste water pump" on page 44
Fault code “:ƒˆ is lit. Mains voltage too low. No appliance fault, have the mains voltage
and electrical installation checked.
A different fault code is
indicated on the digital
display.
(“:‹‚ to “:„‹)
A technical fault has probably
occurred.
Switch off the appliance with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off water supply
and pull out the mains plug.
Call customer service and quote the fault
code.
Home network is not
loading.
WLAN is not active on the router. Check the wireless network connection of
your router.
WLAN display flashes. Connection to the home network
is not available.
Activate the wireless network on your
router.
Home Connect cannot be
implemented correctly.
Possible setting errors or a
technical fault.
Observe the supplied documents and
support information for Home Connect.
Energy manager does not
connect to the energy
manager of the home
system. *
Connection to the energy
manager of the home system is
not available.
Refer to the instructions for use from the
energy manager manufacturer for your
home system.
Refill indicator for salt P
and/or rinse aid H is lit.
No rinse aid. Refill rinse aid.
No salt. Refill with special salt.
Sensor does not detect salt
tablets.
Use different special salt.
Refill indicator for salt P
and/or rinse aid H is not
lit.
Refill indicator switched off. Activation/deactivation (see chapter
“Water softening system/Special salt”
~ Page 19 or “Rinse aid” ~ Page 21).
There is still enough special
salt/rinse aid available.
Check refill indicator, levels.
Fault Reason Remedial action
* depending on the configuration of your specific dishwasher