Need help?Do you have a question about the Bosch AUTODOME IP 5000i and is the answer not in the manual?
General| Digital Zoom | 12x |
|---|---|
| Focal Length | 4.3 - 21.5 mm |
| Aperture | F1.6 - F2.8 |
| Pan Range | 360° continuous |
| Maximum Resolution | 1920 x 1080 |
| Frame Rate | Up to 60 fps |
| Audio Compression | G.711, G.726, AAC |
| Ingress Protection | IP66 |
| Impact Protection | IK10 |
| Lens Type | Varifocal |
| Day/Night | True Day/Night |
| Image Sensor | 1/2.8" CMOS |
| Tilt Speed | 1°/s to 120°/s |
| Video Compression | H.265, H.264, MJPEG |
| Protocols | IPv4, IPv6, HTTP, HTTPS, RTSP, RTP, UDP, TCP, ICMP, IGMP, SNMP, SMTP, FTP, DHCP, DNS, DDNS, NTP, 802.1x, UPnP |
| Operating Temperature | -30 °C to +60 °C (-22 °F to +140 °F) |
| Power Source | 24 VAC, PoE+ (IEEE 802.3at, Class 4) |
| Resolution | 1920 x 1080 |
| Network Interface | RJ45 10/100 Base-T |
| Power Supply | PoE+ (802.3at), 24 VAC ±10% |
| Pan Speed | 0.1°/s to 160°/s |
Follow the installation manual and set the initial password and username for camera access.
Configure encoder profile for 10000 Mbps, highest quality, and 255 Iframe distance.
Set the non-recording profile to 'HD Image Optimized' for stream 1.
Set sensor mode to 50Hz and use H.264 codec in the installer menu.
Disable all OSD effects within the display stamping configuration.
Disable enhancement effects and adjust sharpness level to -15.
Optionally adjust contrast, saturation, or white balance for optimal color.
Navigate to Camera control settings via the EasyConf admin menu.
Select Onvif brand, enter IP, user, and password; invert controls if needed.
Open the EasyCam client settings via F12 or system tray icon.
Set up the Inputs tab with username, password, and RTSP alternative decoder.
To Next Page