62 en | Diagnostics
FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
2020-07 | 3.0 | F.01U.378.877 User Guide Bosch Sicherheitssysteme GmbH
2. VAS
A list of the available voice alarm systems is displayed.
To display information on an available Plena voice alarm system:
Touch one of the systems displayed in order to select it. The following information is
displayed:
– Trouble (yes/no)
– Emergency (yes/no)
– Failure (yes/no)
– Internal monitoring (yes/no)
– Supervision time (sec).
– Boot-up phase is finished (yes/no)
– Failure at controller (yes/no)
– Failure at router (yes/no)
To display information on an available VAS over IP:
Touch the voice alarm system displayed in order to select it. The following information is
displayed:
– Connection status: Shows whether an IP connection to the VAS over IP exists.
– Status of VAS over IP: In case of trouble please check the VAS over IP.
– Trigger configuration:
Mismatch: A VAS Virtual Trigger programmed in the AVENAR panel 8000/2000
configuration cannot be matched to an equivalent trigger on the VAS over IP side. Please
check the mapping of the virtual VAS triggers/virtual control inputs configured in the
FSP-5000-RPS programming software and the VAS over IP configuration.
– Compatibility: Shows whether the version of the connected VAS over IP is released for
the connection to an AVENAR panel 8000/2000. If a warning is displayed please check the
version of the VAS over IP.
– Connection fault counter: Shows the number of connection errors to the VAS over IP
until the last reboot of the panel.
– Address of VAS over IP: IP address of the VAS over IP.
– Port of VAS over IP: VAS over IP port number. The default value is 9401.
To check the availability of the VAS over IP in the network, choose Send ping command to
send a ping request to the VAS over IP IP address.
To Next Page
Loading...
