17 | english
04.2015 | C1 | Battery charger Automotive Aftermarket
Prior to start-up
3 Read the battery operating instructions before
connecting up the charger.
3 Observe the vehicle manufacturer's
recommendation if the battery is still
connected to the vehicle.
3 Clean the battery terminals. When doing so,
do not allow the dirt to come into contact
with your eyes or mouth.
3 Ensure adequate ventilation. Hydrogen gas
(electrolytic gas) may escape from the battery
during charging and trickle charging.
Connection
3 Connect the (+) terminal (red) (5) of the
charger to the (+) terminal of the battery.
3 Connect the (–) terminal (black) (6) of the
charger to the (–) terminal of the battery.
3 The (–) terminal (black) (6) can also be
connected to the car body, however well
away from fuel pipes.
Note: Make sure the (+) and (–) terminals are firm.
3 Only then is the power cord to be connected
to the mains current.
As soon as the charger has been connected to the
mains current, it switches automatically to standby
mode. The “Power” indicator (7) will light up.
Disconnection
3 Switch the charger to standby by pressing
the Mode selection button (8).
3 Always start by disconnecting the power cord
from the mains current.
3 Disconnect the (–) terminal (black) (6)
of the charger from the (–) terminal of the
battery.
3 Disconnect the (+) terminal (red) (5)
of the charger from the (+) terminal of the
battery.
Mode selection
3 Select the required mode by pressing the
mode selection button (8).
3 The LED for the desired mode will light up.
Operation
C1-Komplett-040914.indd 17 08.05.15 10:08
To Next Page
Loading...
