33Bosch Security Systems 3/23 BLCC610U
Solution 6000 User Guide
2. Using the numeric keys, enter all the digits of the
call forward off sequence.
You can change a single digit by scrolling the cursor
left [] and right []. For special characters (eg. , =
pause, * or # etc), use the [] and [] keys.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Email Reporting
In addition to Back to Base monitoring you can also
configure your alarm system to send selected reports to an
email address of your choice. To activate email reporting,
simply enter the email address in MENU 5-5-8 and then
select the required report types in MENU 5-5-9.
The Site Name in MENU 7-7-7 is used in the email subject
line when email reporting. You should also program this
name to make it easier to identify email sent by your alarm
system.
To cancel email reporting simply remove the email address
by going to MENU 5-5-8 and then pressing the [OFF] key
followed by the [OK] key.
Currently email reporting functionality is only
available for panels located in Australia.
Comms > MyAlarm >
Email Address
MENU 5-5-8
This menu allows the master user to program an email
address that the system will send email reports to. A
maximum of 80 characters can be used to program the
email address.
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [8] + [OK].
The keypad will display the current email address.
Email Address
_
Press OK to SAVE
3. Use the numeric, [0] to [9], [] and [] keys to enter
or change the email address as required.
At any time you can use the [] and [] keys to scroll
through the complete list of available characters.
To clear all characters from the cursor position to the
right, press the [OFF] key.
4. When the email address is complete, press [OK] to
save and exit, or press [MENU] to exit without saving.
To stop email reporting simply remove the email
address or disable all of the email options in MENU 5-5-
9.
When entering an email address the @ symbol is
represented on the keypad display as .
To enter this character press the 1 key repeatedly until
the symbol appears in the display.
Comms > MyAlarm >
Email Options
MENU 5-5-9
This menu allows the master user to select which event
types will be reported using the email reporting function.
By default the first 4 options are set to report via email.
Follow the procedure below to configure the required
options.
Option Description
Default
1 Open Close Reports
Send Reports
2 Zones Reports
Send Reports
3 System Reports
Send Reports
4 Access Reports
Send Reports
5 Reserved
6 Reserved
7 Reserved
8 Reserved
Table 7: Email Options
1. Enter your Master PIN + [MENU].
2. Enter [5] + [5] + [9] + [OK].
The keypad will display the list of current options.
Options with a preceeding tick mark are selected.
Open Close
Zones
System
Press OK ON OFF MENU
3. Use the [] and [] keys to highlight the feature that
you want to program, then use the [ON] and [OFF]
keys to turn on and off the features as required.
4. When all email options are programmed, press [OK]
to save and exit, or press [MENU] to exit without
saving.
To Next Page
Loading...
