Solution 6000
34 Bosch Security Systems 3/23 BLCC610U
User Guide
Comms > Periodic Test >
Send Test Report
MENU 5-9-0
This menu allows you to test the reporting functions of the
control panel by manually sending a ‘Test’ report to the
receiving party (i.e. security company monitoring station,
mobile telephone etc).
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [5] + [9] + [0].
The keypad will prompt that it is in the process of
sending a test report.
Comms Testing In
Progress ..Please Wait..
Press OK or MENU
If the test is successful, the keypad will prompt:
Comms Test Successful
Press OK or MENU
If the test is NOT successful, the keypad will prompt:
Test Report Failed..
Please Call For Service
Press OK or MENU
2. Press [OK] or [MENU] to exit.
Devices and Optional Modules
Programming options in this section relate to the keypads
and other devices which may be connected to your alarm
system. Your installer will advise you on the exact makeup
and configuration of your system.
Devices > Commands >
Device Status
MENU 6-0-0
This option provides a listing of all of the devices and
modules connected to your system. Using this option
it is possible to view the voltage, temperature and other
information about each of the modules.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [0].
Kp1 Keypad 1 Name
Kp2 Keypad 2 Name
Ox1 Output Exp 1
Press OK or MENU
2. Use the [] and [] keys to select the device that you
want to view, then press [OK] to select.
The display will show each parameter for the device
one at a time on the third line of the screen.
Keypad 1 Name Kp1
Graphic + Prox V2.05
Voltage = 13.87
Press OK or MENU
4. Press [OK] or [MENU] to exit.
Devices > Commands >
Keypad Volume
MENU 6-0-7
This menu allows you to adjust the volume of the keypad’s
buzzer. Each keypad will need to have their volume
adjusted separately.
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [6] + [0] + [7].
The keypad will display:
L
Press
SAVE
OK
to
H
2. Use the [] and [] keys or use the [] and [] keys
to increase or decrease the volume of the keypad
buzzer until the desired volume has been reached.
3. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Devices > Commands >
Keypad Contrast
MENU 6-0-8
This menu allows you to adjust the contrast of the keypad’s
LCD display. Each keypad can have their display adjusted
separately.
To Next Page
Loading...
